Tastes of Culture

Have you ever really thought about doing this? I think that it is quite a first-class suggestion! Not merely do they offer a personal feel to whomever you choose to dedicate them to, but they what’s more result in utter delight.

Consequently, you may well be keen on the idea, but what will you need to get started? I will give you a list and after that you can decide whether you want to continue.

First of all you will need, what is called, a greeting card mount, which your design will fit into. A craft knife, some silver foil, masking tape, a Pritt glue stick, scissors, a pencil, a sheet of acetate, kitchen roll, a no. 4 round brush, if at all possible water based glass paints and a few tubes of cerne relief outliners.

First step that you will need to take, is to take your acetate piece and cut it a little bit larger than your figure. After that use the masking tape to maintain your acetate in position over your special shape. Using the outliner does not at all times seem simple, and you could do with a somewhat firm hand to direct it.

It is a good idea to practice first with this on any of the acetate piece that you are not going to make use of. Sample removing a little paint from the nozzle and at that time clean the top with the kitchen roll before you start. A excellent rule is to keep the nozzle clean.

If you believe you have got the hang of this and obtained a quite easy flow, make a start by tracing the motif on to the acetate piece and subsequently leave it alone for around twenty minutes to grant it time to dry out.

When you make out that the outliner is in reality dry, if you suffer any unasked for bits, mistakes if you like, you can begin to remedy them, by using the craft knife to incise through the liner, to raise off spare paint, or you can chip bits off any unwanted blobs. After that you will need to repair any areas where you have cut away the paint and then leave them to dry.

When it is dry you can at that moment start to paint your picture, however be generous with the paint. If you don’t make use of much paint, you will discover that you obtain brush strokes showing, which you do not genuinely desire!

What you should do, is to put like a puddle of paint, where you would like it, and you will learn that the outliner is similar to a stop line for the paint. The picture is at this time most likely completed, so only needs to dry.

To lighten up your sketch, set your initial pattern on top of your silver foil next press it very hard with a pencil, to mark out your silhouette. All you want to sort out after that, is to engrave the foil. The image at this time needs to be fixed into the card mount.

Set the silver foil you have a moment ago cut out at the back of the painting also glue it to the portion of the card that folds in behind. Paste the side card downward. You can nevertheless affix some add-on embellishment by means of your outliner if you need to!